Home › Engine / Hybrid System › 2AR-FE FUEL › FUEL PRESSURE PULSATION DAMPER
RM19V0EQ _51 Engine / Hybrid System _014575 2AR-FE FUEL _0073938 FUEL PRESSURE PULSATION DAMPER A

2AR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  INSTALLATION  


PROCEDURE

Hide 23270 1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A196015C03
2.583,1.625 2.771,1.625 2.771,1.625 2.99,1.083 false 2.375,1.542 2.563,1.75 0.188,0.208 10 *1
*1 O-ring


Apply a light coat of gasoline or spindle oil to a new O-ring.


b.

Install the O-ring to the fuel pressure pulsation damper.


c.

Install the fuel pressure pulsation damper with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the damper.



Hide 23901 2.INSTALL FUEL TUBE SUB-ASSEMBLY

A204253C02
1.656,0.573 2.021,0.229 2.021,0.229 2.167,0.229 true 2.938,1.719 2.542,2.656 2.542,2.656 2.552,3.031 true 2.208,0.146 2.385,0.438 0.177,0.292 10 *1 2.469,3.094 2.646,3.406 0.177,0.313 10 *2
*1 No. 2 Fuel Pipe Clamp
*2 Fuel Hose Clamp


a.

Connect the fuel tube.


b.

Push the fuel tube connector until it makes a "click" sound.


c.

Install a new No. 2 fuel pipe clamp.


Hide 3.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY