Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2011.10–2016.05
RM19V0EQ _51 Engine / Hybrid System _014577 2AR-FE INTAKE / EXHAUST _0073948 INTAKE MANIFOLD A

2AR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 5.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55702A 6.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 22030 7.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 17650 8.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a.
A254745

Disconnect the union to connector tube hose and wire harness clamp.


b.

Disconnect the 2 vacuum hoses and connector.


c.

Remove the bolt and vacuum switching valve assembly.


Hide 12262 9.DISCONNECT NO. 2 VENTILATION HOSE

a.
A196046

Disconnect the No. 2 ventilation hose from the intake manifold.


Hide 44774 10.REMOVE UNION TO VACUUM TUBE HOSE (for LHD)

a.
A196048

Disconnect the union to vacuum tube hose from the intake manifold.


Hide 44773F 11.REMOVE UNION TO CHECK VALVE HOSE (for RHD)

a.
A196048

Disconnect the union to check valve hose from the intake manifold.


Hide 23901 12.DISCONNECT FUEL TUBE SUB-ASSEMBLY

Hide 23814B 13.REMOVE FUEL DELIVERY PIPE

Hide 17111 14.REMOVE INTAKE MANIFOLD

a.
A205609

Remove the 2 bolts and 2 wire harness clamp brackets.


b.
A254751

Disconnect the fuel vapor feed hose.


c.

Disconnect the 3 wire harness clamps and connector.


d.

Remove the bolt and wire harness clamp bracket.


e.
A263239

Remove the bolt and separate the wire harness.


f.

Disconnect the 2 wire harness clamps.


g.
A254723

Remove the 6 bolts and intake manifold.


h.
A254724

Remove the intake manifold gasket from the intake manifold.


i.
A196049

Disconnect the 2 vacuum hoses from the intake manifold and remove the No. 1 check valve.


j.
A196050

Remove the bolt and wire harness clamp bracket.