Home › Engine / Hybrid System › 2AR-FE LUBRICATION › OIL PUMP
RM19V0EQ _51 Engine / Hybrid System _014579 2AR-FE LUBRICATION _0073960 OIL PUMP A

2AR-FE LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.


PROCEDURE

Hide 82121 2.REMOVE ENGINE WIRE

Hide 11201 4.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

a.
A195876

Remove the 16 bolts, 3 seal washers, cylinder head cover and gasket.


b.
A196857

Remove the 3 gaskets from the camshaft bearing caps.


Hide 11301K 5.REMOVE CRANKSHAFT POSITION SENSOR

Hide 12315A 7.REMOVE ENGINE MOUNTING BRACKET RH

a.
A203574

Remove the 5 bolts and engine mounting bracket RH.


Hide 16620 8.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 11302 9.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

a.
A196847

Remove the 17 bolts and 2 nuts.


b.
A297601

Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.

NOTICE:

Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase or chain cover.


HINT:

Tape the screwdriver tip before use.



c.
A196858

Remove the 3 gaskets from the stiffening crankcase.


Hide 11301C 10.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A210537C05
1.646,0.281 1.885,0.281 1.885,0.281 2.052,0.656 false 1.385,0.208 1.625,0.427 0.24,0.219 10 *1
*1 Wooden Block


Using a screwdriver and wooden block, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole.


HINT:

Tape the screwdriver tip before use.