Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER
RM19V0EQ _51 Engine / Hybrid System _014580 2AR-FE STARTING _0073966 STARTER A

2AR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 4.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17735 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 28100 9.REMOVE STARTER ASSEMBLY

a.
A254989

Disconnect the starter connector.


b.

Open the terminal cap, remove the nut and disconnect the starter wire.


c.
A254988

Remove the 2 bolts and starter assembly.