Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch to ON.
Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch to ON.
Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch to ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch to ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
45713A
1.INSTALL STEERING SHAKE DAMPER
Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
84633
2.INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)
Install the cruise control switch wire.
84632
3.INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
84523
4.CONNECT NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
84610F
5.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
45116
6.INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Engage the 2 claws, 2 pins and 2 guides to install the No.1 steering wheel ornament.
Install the 2 screws.
45107
7.INSTALL HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch)
Install horn button wire sub-assembly.
84250A
8.INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
9.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
10.INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY
45100
11.INSTALL STEERING WHEEL ASSEMBLY
| *a | Matchmark |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.
12.CHECK STEERING WHEEL CENTER POINT
45130
13.INSTALL HORN BUTTON ASSEMBLY