Home › Drivetrain › CLUTCH › CLUTCH ACCUMULATOR › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073993 CLUTCH ACCUMULATOR A

CLUTCH  CLUTCH ACCUMULATOR  INSTALLATION  


PROCEDURE

Hide 31490 1.INSTALL CLUTCH ACCUMULATOR ASSEMBLY

a.
C204652

Install the clutch accumulator assembly with the 3 bolts.

Torque:
Bolt Length 18 mm (0.709 in.) : 19 N*m (192 kgf*cm, 14 ft.*lbf)
Bolt Length 16 mm (0.630 in.) : 12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 2.CONNECT CLUTCH LINE

a.
C224595N01
1.969,0.708 2.198,1.021 0.229,0.313 10 true D 1.969,0.948 2.198,1.198 0.229,0.25 10 true A 2.479,1.135 2.75,1.521 0.271,0.385 10 false A 3.167,1.198 3.365,1.5 0.198,0.302 10 false B 1.448,0.729 1.646,0.958 0.198,0.229 10 true C 0.563,0.083 0.76,0.292 0.198,0.208 10 true D

Temporarily tighten the clutch line (A).


b.

Install the clutch hose with a new clip (B).


c.

Temporarily tighten the clamp of clutch line with the bolt (C).


d.

Using a (10 mm) union nut wrench, install the 2 clutch lines (A, D).

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



e.

Tighten the clamp of clutch line with the bolt (C).

Torque:
Bolt Length 18 mm (0.709 in.) : 19 N*m (192 kgf*cm, 14 ft.*lbf)
Bolt Length 16 mm (0.630 in.) : 12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 3.FILL BRAKE FLUID RESERVOIR

Hide 4.BLEED CLUTCH LINE

Hide 6.INSPECT FOR FLUID LEAK

HINT:

Check for leaks in the clutch system.


Hide 17750A 7.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 53737B 8.INSTALL FRONT FENDER APRON SEAL LH

Hide 51442C 9.INSTALL ENGINE UNDER COVER LH