Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR › 2011.10–2015.04
RM19V0EQ _53 Suspension _014588 FRONT SUSPENSION _0074022 FRONT STABILIZER BAR A

FRONT SUSPENSION  FRONT STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48815 1.INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

a.
C239287C02
1.063,1.271 1.063,1.813 false 0.969,1.792 1.135,1.948 0.167,0.156 10 *a
*a Cutout
V100135

Front of the Vehicle
V100136

Inside of the Vehicle


Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

NOTICE:

When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.



Hide 48811 2.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar to the front frame assembly.


Hide 48829A 3.INSTALL FRONT NO. 1 STABILIZER BRACKET LH

a.

Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.

Torque:
27 N*m (275 kgf*cm, 20 ft.*lbf)


Hide 48824A 4.INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as the LH side.


Hide 48810 5.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

a.

Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.

Torque:
74 N*m (755 kgf*cm, 55 ft.*lbf)

If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.


Hide 48820B 6.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as the LH side.


Hide 7.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (When Not Using the Engine Support Bridge)

Hide 51100G 8.INSTALL FRONT FRAME ASSEMBLY (When Using the Engine Support Bridge)