45470
1.INSTALL TIE ROD ASSEMBLY LH
| *a | Matchmark |
Install the lock nut and tie rod assembly LH to the steering rack end sub-assembly until the matchmarks are aligned.
After adjusting the front wheel alignment, tighten the lock nut.
45460
2.INSTALL TIE ROD ASSEMBLY RH
Perform the same procedure as for the LH side.
3.INSTALL STEERING LINK ASSEMBLY
Install the steering link assembly with the 2 bolts and 2 nuts.
Keep the nut from rotating while turning the bolt because the nut has its own stopper.
Make sure to tighten the bolts starting from the pinion shaft side.
48811
4.INSTALL FRONT STABILIZER BAR
48829A
5.INSTALL FRONT NO. 1 STABILIZER BRACKET LH
48824A
6.INSTALL FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as for the LH side.
7.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
45470
8.CONNECT TIE ROD ASSEMBLY LH
Connect the tie rod assembly LH to the steering knuckle with the nut.
Install a new cotter pin.
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
45460
9.CONNECT TIE ROD ASSEMBLY RH
Perform the same procedure as for the LH side.
45220
10.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
| *a | Matchmark |
Align the matchmarks and install the steering intermediate shaft to the steering link assembly.
Install the bolt.
11.INSTALL FRONT WHEELS
12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
13.INSPECT STEERING WHEEL CENTER POINT