Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM19V0EQ _56 Audio / Visual / Telematics _014599 AUDIO / VIDEO _0074079 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  INSTALLATION  


PROCEDURE

Hide 86011Q 1.INSTALL RADIO SETTING CONDENSER (for Window Defogger)

a.
E183101

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E221975

Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.




c.

Engage the 2 clamps to temporarily install a new radio setting condenser with wire harness.


d.

Install the new radio setting condenser with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 62472A 2.INSTALL ROOF SIDE INNER GARNISH LH (for Window Defogger)

Hide 62332A 3.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Window Defogger)

Hide 86011R 4.INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light)

a.
E226085

Engage the claw to install a new terminal cover to the wire harness.

NOTICE:
·

Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.

·

Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

·

Do not use excessive force when inserting the wire harness into the terminal cover.

·

If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.




b.
E223710

Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.

NOTICE:
·

Do not use excessive force when inserting the terminal cover into the condenser.

·

If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.




c.
E226095

Engage the claw to insert the cover as shown in the illustration.


d.

Engage the clamp to temporarily install a new radio setting condenser with wire harness.


e.

Install the new radio setting condenser with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 5.INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

Hide 6.INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)

Hide 72693 7.INSTALL REAR SEAT CUSHION LOCK HOOK (for Fixed Seat Type)

Hide 8.INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

Hide 72693 9.INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

Hide 10.INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)