73920A
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY
The nuts must not be reused.
Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
Install the front seat airbag assembly with 2 new nuts.
Engage the 2 clamps.
Engage the claw and 3 clamps to connect the airbag wire harness.
2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
4.CONNECT AIRBAG WIRE HARNESS (for Manual Seat)
Engage the fastener to connect the airbag wire harness.
Connect the rubber band of the separate type front seatback cover with pad.
5.CONNECT AIRBAG WIRE HARNESS (for Power Seat)
Engage the fastener to connect the airbag wire harness.
Connect the rubber band of the separate type front seatback cover with pad.
6.INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
7.INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
8. PERFORM DIAGNOSTIC SYSTEM CHECK