1.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
72693
2.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fixed Seat Type)
3.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
72693
4.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
73480
5.DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for LHD)
73480
6.DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (for RHD)
7.REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)
8.REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
9.REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
73370C
10.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly LH.
73360C
11.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly RH.
62332A
12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH.
62331A
13.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the rear door opening trim weatherstrip RH.
62472A
14.REMOVE ROOF SIDE INNER GARNISH LH
62471A
15.REMOVE ROOF SIDE INNER GARNISH RH
Use the same procedure as for the LH side.
73373F
16.REMOVE REAR SEAT SHOULDER BELT HOLE COVER
Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.
Use the same procedure for the other 2 rear seat shoulder belt covers.
64330D
17.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Disconnect the connector.
| *1 | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the 5 guides.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
64330
18.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
| *1 | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the guide.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
73370C
19.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt.
Disengage the guide to remove the rear No. 1 seat outer belt assembly LH.
73360C
20.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.