Home › Vehicle Interior › HEATING / AIR CONDITIONING › COOLER EXPANSION VALVE
RM19V0EQ _58 Vehicle Interior _014613 HEATING / AIR CONDITIONING _0074196 COOLER EXPANSION VALVE A

HEATING / AIR CONDITIONING  COOLER EXPANSION VALVE  INSTALLATION  


PROCEDURE

Hide 88515 1.INSTALL COOLER EXPANSION VALVE

a.

Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.

Compressor oil:

ND-OIL8 or equivalent



b.

Install 2 new O-rings to the No. 1 cooler evaporator sub-assembly.


c.

Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

Torque:
3.5 N*m (36 kgf*cm, 31 in.*lbf)


Hide 88710E 2.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

Hide 88704 3.CONNECT SUCTION HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape from the hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction hose sub-assembly.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose sub-assembly.


d.
E227143

Move the hook connector in the direction indicated by the arrow in the illustration.


e.

Insert the pipe joint into the fitting hole securely and install the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 55701J 4.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 5.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 6.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 7.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT