55328
1.REMOVE NO. 1 INSTRUMENT PANEL PIN
Remove the 4 screws <C> or <D> and 4 No. 1 instrument panel pins.
73960A
2.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
55843A
3.REMOVE NO. 1 HEATER TO REGISTER DUCT
for LHD:
Remove the clip.
Remove the 3 screws <C> or <D> and No. 1 heater to register duct.
for RHD:
Remove the clip.
Remove the 3 screws <C> or <D> and No. 1 heater to register duct.
55971C
4.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
Remove the screw <C> or <D>.
Disengage the 2 claws to remove the No. 1 side defroster nozzle duct.
55845A
5.REMOVE NO. 3 HEATER TO REGISTER DUCT
for LHD:
Remove the clip.
Remove the 3 screws <C> or <D> and No. 3 heater to register duct.
for RHD:
Remove the clip.
Remove the 3 screws <C> or <D> and No. 3 heater to register duct.
55972C
6.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Remove the screw <C> or <D>.
Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.
86101
7.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
86101
8.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
55950G
9.REMOVE DEFROSTER NOZZLE ASSEMBLY
Remove the 3 screws <C> or <D>.
Disengage the 2 guides to remove the defroster nozzle assembly.
86860
10.REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
55844
11.REMOVE NO. 2 HEATER TO REGISTER DUCT
Remove the 2 screws <C> or <D> and No. 2 heater to register duct.
55012A
12.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
Remove the 2 screws <C> or <D>.
Apply protective tape to the areas shown in the illustration.
| *1 | Protective Tape | - | - |
Disengage the 5 clips as shown in the illustration.
Using a moulding remover, disengage the 8 clips to remove the No. 2 instrument panel garnish sub-assembly as shown in the illustration.