1.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
55845A
2.REMOVE NO. 3 HEATER TO REGISTER DUCT (for LHD)
55843A
3.REMOVE NO. 1 HEATER TO REGISTER DUCT (for RHD)
55972C
4.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
86101
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
Disengage the 8 clamps and remove the antenna cord sub-assembly.
86101
6.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
Disengage the 10 clamps and remove the antenna cord sub-assembly.
7.REMOVE ROOF HEADLINING ASSEMBLY
63341
8.REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)
Remove the No. 1 roof silencer pad.
86101J
9.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Digital Audio Broadcasting Antenna)
Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.
Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Tape | - | - |
| *a | Front | - | - |
86101J
10.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Digital Audio Broadcasting Antenna)
Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.
Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Tape | - | - |
| *a | Front | - | - |