This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB8 | Destination Information Undefined | The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU). | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor RH ·
Blind spot monitor sensor LH |
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.
Check for CAN communication system DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
CAN communication system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Replace the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH (Master) | B |
| DTC is output from the blind spot monitor sensor LH (Slave) | C |
A
B
C