Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0074094 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC No. Detection Item DTC Detection Condition Trouble Area
U1331 Software Incompatibility with Body Control Module "B" Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.
·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.


PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU)
a.

Check the main body ECU part number.

i.

Check if the part number of the main body ECU installed on the vehicle is correct.

OK:

The parts number is correct.




Result:
Proceed to
OK
NG



OK

2.CHECK DTC

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

2.CHECK DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Clear DTCs
50002 313
Body Electrical > Blind Spot Monitor Slave > Clear DTCs
50002 314

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH (Master) B
DTC is output from the blind spot monitor sensor LH (Slave) C



A

B

C