This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for 10 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2786 | No Response from Steering Lock ECU | No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for 10 seconds or more. | ·
Steering lock ECU (steering lock actuator assembly) ·
Certification ECU (smart key ECU assembly) ·
Wire harness or connector ·
STRG LOCK fuse |
Inspect the fuses for circuits related to this system before performing the following procedure.
If the certification ECU (smart key ECU assembly) is replaced, register the keys (refer to the Service Bulletin).
If the steering lock ECU (steering lock actuator assembly) is replaced, register the ECU code (refer to the Service Bulletin).
When using the intelligent tester to troubleshoot with the ignition switch off:
Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
Clear the DTC.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
DTC B2786 is not output.
| Result | Proceed to |
|---|---|
| Only B2786 is output | A |
| DTC B2786 and B2785 are output simultaneously | B |
When DTC B2786 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.
A
B
Disconnect the I24 steering lock ECU (steering lock actuator assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I24-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I24-7 (B) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I78-17 (LIN) - I24-5 (LIN) | Always | Below 1 Ω |
| I78-17 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the steering lock ECU (steering lock actuator assembly).
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTC.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
DTC B2786 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG