DESCRIPTION
When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the skid control ECU.
The skid control ECU records DTCs when it detects a malfunction in itself or in its circuits.
To check for DTCs, connect the intelligent tester to the DLC3 on the vehicle. The intelligent tester can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.
Check the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge the battery before proceeding to the next step.
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
DIAGNOSIS
If the skid control ECU detects a malfunction, the ABS warning and/or brake warning lights will come on in order to warn the driver.
The DTCs are simultaneously stored in memory.
The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning light, or by connecting the intelligent tester.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
This system has a Test Mode (signal check) function.
The DTCs can be read by connecting SST between terminals TS and CG of the DLC3 and observing the blinking pattern of the ABS warning light, or by connecting the intelligent tester.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
WARNING LIGHT INITIAL CHECK
Release the parking brake.
Before releasing the parking brake, set the chocks to hold the vehicle for safety.
When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.
When the ignition switch is turned to ON, check that the ABS warning and brake warning lights all come on for approximately 3 seconds.
If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning and brake warning light circuits.
If the indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.