Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)
RM19V0EQ _58 Vehicle Interior _014606 THEFT DETERRENT / KEYLESS ENTRY _0074131 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) Y

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use this procedure to troubleshoot the theft deterrent system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
HINT:
·

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in the problem analysis:



What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms

Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

4.CRANK ENGINE FOR MORE THAN 10 SECONDS
4.CRANK ENGINE FOR MORE THAN 10 SECONDS
Result:
Proceed to
NEXT



NEXT

5.CHECK FOR DTCS (ENGINE IMMOBILISER SYSTEM)*
5.CHECK FOR DTCS (ENGINE IMMOBILISER SYSTEM)*
a.

Check for DTCs and note any codes that are output.

Body Electrical > Immobiliser > Trouble Codes
50001 260

b.

c.

Recheck for DTCs. Based on the DTCs output above, try to duplicate the engine immobiliser system DTC by simulating the symptoms indicated by the DTCs.

Body Electrical > Immobiliser > Trouble Codes
50001 260
Result:
Result Proceed to
No DTCs are output A
Engine immobiliser system DTC is output B




A

6.CHECK FOR DTCS (SFI SYSTEM)*

B

6.CHECK FOR DTCS (SFI SYSTEM)*

b.

Recheck for DTCs.

Powertrain > Engine and ECT > Trouble Codes
50001 234
HINT:

The DTCs for the engine immobiliser system are specified below. If other DTCs are output, check the DTC chart for the SFI system.


Result:
Result Proceed to
No DTCs are output A
Engine immobiliser system DTC is output (DTC B2799, B279A or B279C) B
SFI system DTC is output (except DTC B2799, B279A and B279C) C




A

7.READ VALUE USING INTELLIGENT TESTER*

B

C

7.READ VALUE USING INTELLIGENT TESTER*
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Immobiliser / Data List.


e.

Read the Data List according to the display on the intelligent tester.

Body Electrical > Immobiliser > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Key SW Unlock warning switch signal ON or OFF ON: Key in ignition key cylinder
OFF: No key in ignition key cylinder
-
Body Electrical > Immobiliser > Data List
Tester Display
Key SW
50003 260 3
OK:

On the intelligent tester screen, the item changes between ON and OFF according to the chart above.



Result:
Proceed to
OK
NG



OK

8.PROBLEM SYMPTOMS TABLE

NG

8.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B




A

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

10.REPAIR OR REPLACE
10.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST
11.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END