·
Throttle with motor body assembly
·
Cleaning the deposits from the throttle with motor body assembly
·
Cylinder head sub-assembly
·
Camshaft
(for intake or exhaust camshaft)
·
Camshaft timing gear assembly
·
Camshaft timing exhaust gear assembly
·
Mass air flow meter sub-assembly
·
Engine coolant temperature sensor
·
Air leaks from intake system
·
Gas leaks from exhaust system
|
Inspection after repair
|
Poor idle, engine starting, etc
|
( )
|
| Automatic transaxle assembly
|
2.
Input transaxle compensation code into ECM
3.
Perform road test to allow ECM to learn
|
·
The deterioration of fuel efficiency
|
( )for Initialization
( )for Registration
|
·
Shift solenoid valve SL3 and/or SL4
|
2.
Reset transaxle compensation code
3.
Perform road test to allow ECM to learn
|
·
The deterioration of fuel efficiency
|
| Shift solenoid valve SL1 and/or SL2
|
Perform road test to allow ECM to learn
|
·
The deterioration of fuel efficiency
|
| ECM (If possible, read the transaxle compensation code from the previous ECM)
|
Possible
|
2.
Transfer transaxle compensation code
3.
Perform road test to allow ECM to learn
|
·
The deterioration of fuel efficiency
|
| Impossible
|
2.
Reset transaxle compensation code
3.
Perform road test to allow ECM to learn
|
·
The deterioration of fuel efficiency
|
| Skid control ECU (Brake actuator assembly)
|
Perform system variant learning
|
·
Slip indicator light illumination
·
VSC disabled or malfunctioning
|
( )
|
| Power steering ECU assembly
|
Assist map writing
|
·
P/S warning light comes on
|
( )
|
·
Spiral cable sub-assembly
·
Spiral cable with sensor sub-assembly
|
·
Correct steering angle neutral point
|
Parking assist monitor system
|
( )for Initialization
( )for Calibration
|
| Navigation ECU sub-assembly
|
Navigation ECU sub-assembly initialization
|
Parking assist monitor system
|
·
Rear television camera assembly
|
Back camera position setting
|
Parking assist monitor system
|
| ECM
|
Code registration (Engine immobiliser system)
|
Engine start
|
See the Service Bulletin for the registration method.
|
·
Certification ECU (smart key ECU assembly)*1
·
Steering lock ECU (steering lock actuator assembly)*1
·
Electrical key transmitter (key)*1
|
Code registration (Engine immobiliser system)
|
·
Wireless door lock control system
·
Smart entry and start system
|
See the Service Bulletin for the registration method.
|
·
Transponder key ECU assembly*2
·
Door control transmitter assembly*2
|
Code registration (Engine immobiliser system)
|
Engine start
|
See the Service Bulletin for the registration method.
|
·
Door control transmitter*2
|
Code registration (Wireless door lock system)
|
Wireless door lock control system
|
( )
|
·
No. 1 air conditioning radiator damper servo sub-assembly*3, *4
·
No. 2 air conditioning radiator damper servo sub-assembly*3
·
No. 1 blower damper servo sub-assembly*3, *4
|
Initialization servo motor (Air conditioning system)
|
DTCs are output
|
( )*3
( )*4
|
·
Door window regulator assembly*5
·
Power window regulator motor assembly (for driver door)*5
|
Initialize power window control system*5
|
·
Jam protection function*5
·
Operation function after ignition switch is turned off
·
Wireless transmitter-linked function*6
|
( )
|
·
Sliding roof ECU (sliding roof drive gear sub-assembly)
·
Sliding roof glass sub-assembly
·
Sliding roof drive cable sub-assembly
|
Initialize sliding roof ECU (pulse sensor initial position setting)
|
·
Automatic slide open/close and tilt up/down function of sliding roof
·
Operation function after ignition switch is turned off
·
Wireless transmitter-linked function*6
·
Sliding roof open warning
|
( )
|