INITIALIZATION
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION
If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (w/o smart entry and start system) (Refer to the Service Bulletin for Registration).
Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page Drivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).
Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.
WHEN USING GTS
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs depending on the specifications of the vehicle.
The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |