Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › from 2015.04
RM19V0EQ _59 Vehicle Exterior _014618 DOOR / HATCH _0074222 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable through the upper radiator support.


c.

Engage the hood cable grommet.


d.

Engage the 5 clamps and install the hood lock control cable assembly.


Hide 53630 2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable through the upper radiator support.


c.

Engage the hood cable grommet.


d.

Engage the 4 clamps and install the hood lock control cable assembly.


Hide 53510 3.INSTALL HOOD LOCK ASSEMBLY (for LHD)

a.
B400612

Apply MP grease to the sliding areas of the lock.


b.

Connect the hood lock control cable assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.



Hide 53510 4.INSTALL HOOD LOCK ASSEMBLY (for RHD)

a.
B400613

Apply MP grease to the sliding areas of the lock.


b.

Connect the hood lock control cable assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.



d.

Connect the connector.


Hide 53601 5.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.


Hide 53601 6.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 62112A 7.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

Hide 67914 8.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 62111A 9.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 67913 10.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 53876A 11.INSTALL FRONT FENDER LINER LH (for LHD)

HINT:

Use the same procedure for the RH side and LH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 12.INSTALL FRONT WHEEL LH (for LHD)

Hide 53875A 13.INSTALL FRONT FENDER LINER RH (for RHD)

Hide 53851Z 14.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

Hide 15.INSTALL FRONT WHEEL RH (for RHD)

Hide 52611 16.INSTALL FRONT BUMPER ENERGY ABSORBER (for RHD)

w/o Dynamic Radar Cruise Control System:

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REASSEMBLY

Hide 17.INSTALL FRONT BUMPER ASSEMBLY (w/o Dynamic Radar Cruise Control System)

Hide 88211B 18.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Hide 53301 19.ADJUST HOOD SUB-ASSEMBLY