Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0166363 DRIVING SUPPORT ECU A

CRUISE CONTROL  DRIVING SUPPORT ECU  INSTALLATION  


PROCEDURE

Hide 88150A 1.INSTALL DRIVING SUPPORT ECU ASSEMBLY

a.

Connect the connector.


b.

Engage the clamp.


c.

Engage the guide.


d.

Install the driving support ECU assembly with the nut.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 55303B 2.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55607 3.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55318C 4.INSTALL INSTRUMENT SIDE PANEL LH

Hide 62312B 5.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 62112A 6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 67914 7.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION