The main body ECU (multiplex network body ECU) controls the high beam headlights via the engine room junction block assembly.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Head Light Hi | High beam headlights | ON/OFF | - |
| Tester Display |
|---|
| Head Light Hi |
The high beam headlights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using a voltmeter, check the signal reading of the engine room junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>ON-VEHICLE INSPECTION
Output signal reading is normal
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the engine room junction block assembly from the engine room relay block and junction block assembly.
| *a | Component without engine room junction block assembly
(Engine Room Relay Block and Junction Block Assembly) |
- | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-1 (BATT) - Body ground | Always | 11 to 14 V |
| B-1 (ALT) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1F-3 (GND1) - Body ground | Always | Below 1 Ω |
| 1G-4 (GND2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1F-5 - 3D-39 | Always | Below 1 Ω |
| 3D-39 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-39 - MB-26 (DIM) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the engine room junction block assembly with a new or known good one.
Click herePower Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL
Check that the high beam headlights operate normally.
The high beam headlights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG