1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE LOWER STEERING COLUMN COVER
5.REMOVE UPPER STEERING COLUMN COVER
89782
6.REMOVE TRANSPONDER KEY COIL
7.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
84052
8.REMOVE UNLOCK WARNING SWITCH ASSEMBLY
Disconnect the connector.
| *a | Center Part |
Remove the unlock warning switch assembly by pushing up the center part and releasing the 2 claws.
Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to remove it.