CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (ECM MAIN LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A25-13 (CANH) - A25-26 (CANL) | Cable disconnected from negative (-) battery terminal | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 2.CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit.
for 2GR-FE: Click here
for 2AR-FE: Click here
| Result | Proceed to |
| OK (for 2GR-FE) | A |
| OK (for 2AR-FE) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||