REAR SHOCK ABSORBER > INSTALLATION |
| 1. INSTALL REAR LOWER COIL SPRING INSULATOR |
![]() |
Install the rear lower coil spring insulator onto the rear shock absorber assembly.
| *a | Protrusion |
| 2. INSTALL REAR NO. 1 SPRING BUMPER |
Install the rear No. 1 spring bumper to rear shock absorber assembly.
| 3. INSTALL REAR COIL SPRING |
![]() |
Secure SST in a vise.
![]() |
Attach the arm of SST to the diameter of the rear coil spring.
Using SST, compress the rear coil spring.
![]() |
Install the rear coil spring to the rear shock absorber assembly.
| 4. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY |
![]() |
Install the rear suspension support assembly to the rear shock absorber assembly.
| *a | Notch |
![]() |
Align the notches of the rear shock absorber assembly with the notch of the rear suspension support assembly so that the notches face the outside of the vehicle.
| *a | Notch |
![]() | Outside of the Vehicle |
| 5. INSTALL REAR SUPPORT TO REAR SHOCK ABSORBER COLLAR |
Install the rear support to rear shock absorber collar to the rear shock absorber assembly.
| 6. TEMPORARILY TIGHTEN REAR SUPPORT TO REAR SHOCK ABSORBER NUT |
Temporarily tighten a new rear support to rear shock absorber nut to the rear shock absorber assembly.
![]() |
Release the rear coil spring while adjusting the rear suspension support assembly to the position shown in the illustration, and remove SST from the rear coil spring.
| 7. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING |
![]() |
Install the rear shock absorber with coil spring to the rear axle carrier sub-assembly and insert the 2 bolts from the rear of the vehicle.
Slowly jack up the suspension using a wooden block and install the rear shock absorber with coil spring (upper side) to the vehicle.
Install the 3 nuts to the upper side of the rear shock absorber with coil spring.
Install the 2 nuts to the lower side of the rear shock absorber with coil spring.
Fully tighten the rear support to rear shock absorber nut.
| 8. INSTALL SKID CONTROL SENSOR WIRE |
![]() |
Install the skid control sensor wire and rear flexible hose to the rear shock absorber assembly with the 2 bolts.
| *a | Bolt (A) |
| *b | Bolt (B) |
| 9. INSTALL REAR STABILIZER LINK ASSEMBLY |
Install the rear stabilizer link assembly to the rear shock absorber assembly with the nut.
| 10. INSTALL REAR NO. 1 SUSPENSION SUPPORT COVER |
Engage the 4 claws and install the rear No. 1 suspension support cover.
| 11. INSTALL REAR WHEEL |
| 12. INSTALL REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type) |
| 13. INSTALL REAR SEATBACK ASSEMBLY (for Reclining Seat Type) |
| 14. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |