FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 6. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Remove the No. 1 fuel pipe clamp.
![]() |
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
| *1 | Fuel Pipe |
| *2 | Fuel Tube Connector |
| *3 | Nylon Tube |
| *4 | O-ring |
| *5 | Retainer |
![]() | Pinch |
![]() | Pull |
Remove the fuel tube sub-assembly from the fuel hose clamp.
| 7. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) |
![]() |
Disconnect the union to connector tube hose and wire harness clamp.
Disconnect the 2 vacuum hoses and connector.
Remove the bolt and vacuum switching valve assembly.
![]() |
Remove the bolt and vacuum hose clamp.
| 8. DISCONNECT WIRE HARNESS |
![]() |
Disconnect the 4 fuel injector connectors.
Disconnect the 2 connectors.
Remove the 2 bolts and Separate the 2 wire harness brackets.
Disengage the clamp to disconnect the wire harness.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injectors.
![]() |
Remove the 2 fuel delivery spacers from the cylinder head.
Remove the 4 injector vibration insulators from the cylinder head.
| 10. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injectors out of the fuel delivery pipe.
Remove the O-ring from each fuel injector.
For reinstallation, attach a tag or label to each injector shaft.