FUEL PUMP > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.
Repeat the step above for the other hook.
w/ Seat Heater System:
Disconnect the 2 seat heater connectors.
Remove the rear seat cushion assembly.
| 6. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Disengage the claw and remove the rear seat cushion lock hook.
| 7. REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Disengage the claw and remove the rear seat cushion lock hook.
| 8. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() |
Remove the rear floor service hole cover.
Disconnect the fuel pump connector.
| 9. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Remove the tube joint clip, and pull out the fuel pump tube.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | Fuel Pump Tube |
| *4 | O-ring |
| *5 | Fuel Suction Plate |
| 10. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and set plate.
| 11. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Remove the fuel suction tube with pump and gauge assembly from the fuel tank.
![]() |
Remove the fuel suction tube set gasket from the fuel suction tube assembly.
| *1 | Fuel Suction Tube Set Gasket |