PARKING BRAKE PEDAL (for LHD) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE SHIFT LEVER SUPPORT |
| 4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag) |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Remove the 4 bolts.
Disengage the 2 claws to disconnect the DLC3.
![]() |
Disengage the 2 hooks to remove the lower No. 1 instrument panel airbag assembly.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.
| 5. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for Built-in Type Yaw Rate Sensor) |
| 6. REMOVE YAW RATE SENSOR (for Separate Type Yaw Rate Sensor) |
![]() |
Disconnect the connector from the yaw rate sensor.
Remove the 2 nuts and yaw rate sensor.
| 7. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for Separate Type Yaw Rate Sensor) |
| 8. REMOVE YAW RATE SENSOR BRACKET (for Separate Type Yaw Rate Sensor) |
![]() |
Disengage the 2 clamps to separate the wire harnesses.
Remove the 2 bolts and yaw rate sensor bracket.
| 9. REMOVE FLOOR CARPET BRACKET RH |
![]() |
Remove the 2 clips.
Disengage the 2 guides to remove the floor carpet bracket RH.
| 10. REMOVE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Turn back the carpet.
![]() |
Disconnect the connectors from the airbag sensor assembly as shown in the illustration.
Remove the 3 bolts and airbag sensor assembly.
| 11. LOOSEN ADJUSTING NUT |
![]() |
Remove the lock nut and loosen the adjusting nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
| 12. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
| 13. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY |
Turn back the floor carpet.
![]() |
Remove the clip from the No. 1 parking brake cable assembly.
Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.
![]() |
Disconnect the parking brake switch connector.
![]() |
Remove the bolt, 2 nuts and parking brake control pedal assembly.