PARKING BRAKE PEDAL (for RHD) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 4. REMOVE FRONT WHEEL RH |
| 5. REMOVE SHIFT LEVER SUPPORT |
| 6. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY |
![]() |
Disengage the clamp.
Remove the bolt.
Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.
| 7. REMOVE FLOOR CARPET BRACKET RH |
![]() |
Remove the 2 clips.
Disengage the 2 guides to remove the floor carpet bracket RH.
| 8. REMOVE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Turn back the carpet.
![]() |
Disconnect the connectors from the airbag sensor assembly as shown in the illustration.
Remove the 3 bolts and airbag sensor assembly.
| 9. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL |
![]() |
Disengage the 2 claws and 4 clips to remove the upper instrument panel finish panel as shown in the illustration.
w/ Smart Entry and Start System:
Disconnect the connector.
| 10. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY |
| 11. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Manual Tilt and Manual Telescopic Steering Column:
Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
![]() |
Using a moulding remover, disengage the 4 clips and 2 guides.
for LHD:
![]() |
Disengage the 3 claws, 7 clips and 4 guides.
for RHD:
![]() |
Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.
Disconnect each connector.
![]() |
Remove the instrument cluster finish panel assembly as shown in the illustration.
| 12. REMOVE COMBINATION METER ASSEMBLY |
| 13. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY |
![]() |
Remove the bolt.
Disengage the 2 claws to remove the No. 2 air duct sub-assembly.
| 14. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY |
| 15. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY |
| 16. LOOSEN ADJUSTING NUT |
![]() |
Remove the lock nut and loosen the adjusting nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
| 17. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
| 18. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY |
![]() |
Remove the clip from the No. 1 parking brake cable assembly.
Remove the bolt and separate the No. 1 parking brake cable assembly.
![]() |
Disconnect the parking brake switch connector.
![]() |
Remove the bolt, 2 nuts and parking brake control pedal assembly.