DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | An open in the electronic throttle control system power source (+BM) circuit (1 trip detection logic). |
|
| Related DTCs | P2118: Throttle actuator power supply line range check (low voltage) |
| Required Sensors/Components (Main) | Throttle actuator Throttle valve (throttle with motor body assembly) ETCS fuse |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.8 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Electronic throttle actuator power | On |
| Battery voltage | 8 V or higher |
| Throttle actuator power supply voltage (+BM) | Less than 4 V |
| Electronic throttle control | Normal |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ VALUE USING TECHSTREAM (+BM VOLTAGE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Gas Throttle / +BM Voltage.
Read the value displayed on the Techstream.
| Result | Proceed to |
| Less than 4 V | A |
| 11 to 14 V | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - BATTERY, BODY GROUND) |
Disconnect the ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E26-29 (+BM) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E26-58 (ME01) - Body ground | Always | Below 1 Ω |
| E26-16 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||