Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

When there is a short to GND in the power supply for the transponder key amplifier of the engine switch, the certification ECU (smart key ECU assembly) stores this DTC.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B278A
A short to GND in the power supply of the transponder key amplifier of the engine switch (VC5 - VC5) (1 trip detection logic*).
  1. Wire harness or connector
  1. Engine switch
  1. Certification ECU (smart key ECU assembly)
With the shift lever in P, the key held near the engine switch and an engine start operation is performed by pressing and holding the engine switch when the key battery is depleted.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started when key battery is depleted by holding key near engine switch and pressing and holding engine switch with shift lever in P
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B278A
-

WIRING DIAGRAM


B271005E08


INSPECTION PROCEDURE

NOTICE:
  1. Before replacing the certification ECU (smart key ECU assembly), refer to Registration (Click here).
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - ENGINE SWITCH)
  1. Disconnect the I78 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the I58 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I78-1 (VC5) - I58-10 (VC5)
    Always
    Below 1 Ω
    I78-24 (AGND) - I58-6 (AGND)
    Always
    Below 1 Ω
    I58-10 (VC5) - Body ground
    Always
    10 kΩ or higher
    I58-6 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
  1. Reconnect the I58 engine switch and I78 certification ECU (smart key ECU assembly) connector.



    B271009E02
  1. Using an oscilloscope, check the waveform.

    HINT:
    Perform this inspection on the engine switch side.

    Measurement Condition 
    Item
    Content
    Tester Connection
    I58-10 (VC5) - I58-6 (AGND)
    Tool Setting
    2 V/DIV., 200 ms./DIV.
    Condition
    Engine switch off, key not in cabin, within 30 seconds after engine switch pressed

    OK:
    Waveform is output normally (refer to illustration).

    Text in Illustration 
    *a
    Component with harness connected
    (Engine Switch)

    Result:
    Result
    Proceed to
    OK (for 2GR-FE)
    A
    OK (for 2AR-FE)
    B
    NG
    C



B
REPLACE ENGINE SWITCH (Click here)

C
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
A

REPLACE ENGINE SWITCH (Click here)