Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light.

WIRING DIAGRAM


C240100E03


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC (C2179/79)
  1. Check if DTC C2179/79 is output (Click here).

    Result:

    Result
    Proceed to
    DTC C2179/79 is not output.
    A
    DTC C2179/79 is output.
    B



B
GO TO DTC C2179/79 (Click here)
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 2AR-FE 
    Tester Connection
    Condition
    Specified Condition
    I39-13 (TC) - A25-23 (TC)
    Always
    Below 1 Ω
    for 2GR-FE 
    Tester Connection
    Condition
    Specified Condition
    I39-13 (TC) - A25-45 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C207407E18
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I39-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT DLC3 (TC VOLTAGE)


    C207407E33
  1. Connect the ECM connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I39-13 (TC) - I39-4 (CG)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of DLC3

Result:
Condition
Proceed to
OK
A
NG (for 2AR-FE)
B
NG (for 2GR-FE)
C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)