Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

SMART KEY SYSTEM (for Start Function) > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name
See Procedure
Parking Assist Monitor System
Click here


2.DOOR CONTROL RECEIVER EXPRESSIONS
  1. The type of door control receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.

    Vehicle Specification
    Part Name in Manual
    Actual Part Name
    w/ Tire Pressure Warning System
    Door control receiver
    Door control and tire pressure monitoring system receiver assembly
    w/o Tire Pressure Warning System
    Door control receiver
    Door control receiver


3.PRECAUTIONS WHEN USING TECHSTREAM
  1. When using the Techstream with the engine switch off to troubleshoot the smart key system (for Start Function):
    Connect the Techstream to the DLC3 and turn a door courtesy light on and off at 1.5-second or less intervals until communication between the Techstream and vehicle begins (the Techstream screen changes when communication begins).


4.PRECAUTION FOR REGISTRATION
  1. If replacing any of the following parts, refer to the registration procedures (Click here).

    1. Certification ECU (smart key ECU assembly)

    2. Steering lock actuator assembly (steering lock ECU)

    3. Electrical key transmitter sub-assembly