REAR LOWER ARM > INSTALLATION |
| 1. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY |
![]() |
Temporarily tighten the rear No. 1 suspension arm assembly (inner side) with the bolt.
![]() | Bolt |
![]() | Front of the Vehicle |
![]() | Paint Mark |
![]() |
Set the rear No.1 suspension arm assembly in the position shown in the illustration, and fully tighten the bolt.
| 2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY |
| 3. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY |
![]() |
Temporarily tighten the rear No. 2 suspension arm assembly (inside) with the bolt.
![]() | Bolt |
![]() | Paint Mark |
| 4. CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY |
Connect the rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.
| 5. STABILIZE SUSPENSION |
![]() |
Jack up the rear axle carrier sub-assembly, placing a wooden block under it to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm assembly (inner side) is horizontally aligned with the center of the rear axle hub.
| *1 | Wooden Block |
| 6. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY |
![]() |
Fully tighten the 2 bolts.
| 7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor) |
| 8. INSTALL REAR WHEELS |
| 9. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |
| 10. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ Height Control Sensor) |
| 11. ADJUST HEADLIGHT AIMING (w/ Height Control Sensor) |