Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly LH.

HINT:
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.


WIRING DIAGRAM


B289103E06


INSPECTION PROCEDURE

NOTICE:
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (Click here).

1.CHECK DTC OUTPUT (AIRBAG SYSTEM)
  1. Clear DTCs (Click here).*1

  1. Clear DTCs (Click here).*2

  1. Recheck for DTCs (Click here).*1

  1. Recheck for DTCs (Click here).*2

    1. *1: for Built-in Type Yaw Rate Sensor
    2. *2: for Separate Type Yaw Rate Sensor

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for Built-in Type Yaw Rate Sensor)
    B
    DTC is output (for Separate Type Yaw Rate Sensor)
    C



B
GO TO AIRBAG SYSTEM (Click here)

C
GO TO AIRBAG SYSTEM (Click here)
A


2.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / SRS Airbag / Data List.

  1. Read the Data List according to the display on the Techstream.

    SRS Airbag (Airbag Sensor Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Left side Buckle SW
    LH buckle switch/Unset, Set or NG
    Unset: Seat belt not fastened
    Set: Seat belt fastened
    NG: Data is not determined
    -
    Result 
    Result
    Proceed to
    Unset or Set is displayed on the Techstream screen according to the driver seat belt condition
    A
    Unset or Set is not displayed normally on the Techstream screen according to the driver seat belt condition
    (for Manual Seat)
    B
    Unset or Set is not displayed normally on the Techstream screen according to the driver seat belt condition
    (for Power Seat)
    C
    NG is displayed on the Techstream screen
    D



B
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH (Click here)

C
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH (Click here)

D
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A


3.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Replace the main body ECU (multiplex network body ECU) (Click here).


NEXT


4.CHECK SEAT BELT WARNING LIGHT
  1. Check the operation of the seat belt warning light (Click here).

    OK:
    The seat belt warning light operates normally.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)