SEAT BELT WARNING SYSTEM > Front Passenger Side Seat Belt Warning Light Malfunction |

| 1.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM) |
Clear DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK DTC OUTPUT (AIRBAG SYSTEM) |
Clear DTCs (Click here).*1
Clear DTCs (Click here).*2
Recheck for DTCs (Click here).*1
Recheck for DTCs (Click here).*2
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for Built-in Type Yaw Rate Sensor) | B |
| DTC is output (for Separate Type Yaw Rate Sensor) | C |
|
| ||||
|
| ||||
| A | |
| 3.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Occupant Detection / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Passenger Buckle SW | Front passenger buckle switch/Set, Unset or NG | Set: Seat belt fastened Unset: Seat belt not fastened NG: Data is not determined | - |
| Result | Proceed to |
| Unset or Set is displayed on the Techstream screen according to the front passenger seat belt condition | A |
| Unset or Set is not displayed normally on the Techstream screen according to the front passenger seat belt condition (for Manual Seat) | B |
| Unset or Set is not displayed normally on the Techstream screen according to the front passenger seat belt condition (for Power Seat) | C |
| NG is displayed on the Techstream screen | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Right side Buckle SW | RH buckle switch/Unset, Set or NG | Unset: Seat belt is not fastened Set: Seat belt is fastened NG: Data is not determined | - |
| Result | Proceed to |
| Unset or Set is displayed on the Techstream screen according to the front passenger seat belt condition | A |
| B |
|
| ||||
| A | ||
| ||