NAVIGATION RECEIVER > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL NAVIGATION COMPUTER SUB-ASSEMBLY |
| 3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Engage the guide and 4 clips to install the air conditioning control assembly as shown in the illustration.
| 4. INSTALL HARD DISK DRIVE |
![]() |
Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.
Engage the 2 guides to temporarily install the cover.
Install the cover with the 2 screws.
| 5. INSTALL NO. 1 RADIO RECEIVER BRACKET |
Install the No. 1 radio receiver bracket with the 5 screws.
| 6. INSTALL NO. 2 RADIO RECEIVER BRACKET |
Install the No. 2 radio receiver bracket with the 5 screws.
| 7. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY |
Connect each connector.
Engage the 8 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.
Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.
| 8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 6 clips to install the No. 2 instrument panel register assembly.
| 9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Connect the connector.
Engage the clamp.
![]() |
Engage the 6 clips and 7 claws to install the center instrument cluster finish panel assembly.
| 10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
Connect each connector.
Engage the 4 clips and guide.
Install the upper console panel sub-assembly with the 2 screws <C> or <D>.
| 11. INSTALL BOX BOTTOM MAT |
Install the box bottom mat.
| 12. INSTALL REAR CONSOLE BOX ASSEMBLY |
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 14. INSPECT HARD DISK DRIVE |
| 15. REPLACED OPERATION (w/ Parking Assist Monitor System) |