STEERING GEAR > REMOVAL |
| 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 2. REMOVE FRONT WHEELS |
| 3. SECURE STEERING WHEEL |
![]() |
Secure the steering wheel with the seat belt in order to prevent rotation.
| 4. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the steering intermediate shaft assembly and steering link assembly.
| *a | Matchmark |
Remove the bolt.
Separate the steering intermediate shaft assembly from the steering link assembly.
| 5. SEPARATE TIE ROD ASSEMBLY LH |
![]() |
Remove the cotter pin and nut.
![]() |
Install SST to the tie rod assembly LH.
Secure SST using a string.
Using SST, separate the tie rod assembly LH from the steering knuckle.

| *1 | Center Nut | - | - |
| *a | String | *b | Grease Application Area |
![]() | Place the wrench here. | - | - |
| 6. SEPARATE TIE ROD ASSEMBLY RH |
| 7. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
| 8. REMOVE NO. 1 FRONT STABILIZER BRACKET LH |
![]() |
Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
| 9. REMOVE NO. 1 FRONT STABILIZER BRACKET RH |
| 10. REMOVE FRONT STABILIZER BAR |
Remove the front stabilizer bar from the front frame assembly.
| 11. REMOVE STEERING LINK ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and steering link assembly.
| 12. SECURE STEERING LINK ASSEMBLY |
![]() |
Using SST, secure the steering link assembly in a vise.
| *1 | Protective Tape |
| 13. REMOVE TIE ROD ASSEMBLY LH |
![]() |
Put matchmarks on the tie rod assembly LH and the steering rack end sub-assembly.
| *a | Matchmark |
Remove the tie rod assembly LH and lock nut.
| 14. REMOVE TIE ROD ASSEMBLY RH |