METER / GAUGE SYSTEM > Meter Illumination is Always Dark |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| CAN communication DTC is not output. | A |
| CAN communication DTC is output. | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (ILLUMINATION RATE INFO) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Illumination Rate Info | Illumination rate information/0 ms. to 2162.65 ms. | Value output according to ambient light level | - |
| Result | Proceed to |
| The output value changes according to the ambient light level. | A |
| The output value does not change according to the ambient light level. | B |
|
| ||||
| A | |
| 3.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Replace the main body ECU (multiplex network body ECU) with a new or a known good one (Click here).
|
| ||||
| OK | ||
| ||