Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat)

FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect each connector and clamp under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B281469E01
  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B281470E01
  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



2. INSPECT SEAT SLIDE ADJUSTER LOCKS
  1. During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.



3. INSTALL REAR INNER SEAT TRACK BRACKET COVER
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Engage the 2 claws to install the rear inner seat track bracket cover.



4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER
  1. Engage the 2 claws to install the rear outer seat track bracket cover.



5. INSTALL FRONT SEAT HEADREST ASSEMBLY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here)



7. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)
(Click here)


8. INSPECT SRS WARNING LIGHT
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)