Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when one of the following occurs: 1) the ECM detects errors in its own communication with the transponder key ECU assembly; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU assembly and ECM is different and an engine start is attempted.

DTC No.
DTC Detection Condition
Trouble Area
B2799
One of the following conditions is met:
  1. Error in communication between ECM and transponder key ECU assembly.
  2. Error in communication lines.
  3. Communication ID is different during communication with transponder key ECU assembly.
  1. Wire harness or connector
  2. ECM
  3. Transponder key ECU assembly

WIRING DIAGRAM


B255097E04


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly or ECM is replaced, refer to Registration (Click here).

HINT:
If the transponder key ECU assembly DTC is output simultaneously, troubleshoot the transponder key ECU assembly DTCs first.

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.RE-REGISTER ECU COMMUNICATION ID
  1. Re-register the ECU communication ID (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
Go to step 4
OK

END (ECU COMMUNICATION ID WAS NOT REGISTERED CORRECTLY) 

4.CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch off.

  1. Check that the connectors are properly connected to the ECM and transponder key ECU assembly.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the transponder key ECU assembly connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I19-12 (EFII) - A25-29 (IMO)
    Always
    Below 1 Ω
    I19-13 (EFIO) - A25-28 (IMI)
    Always
    Below 1 Ω
    I19-12 (EFII) - Body ground
    Always
    10 kΩ or higher
    I19-13 (EFIO) - Body ground
    Always
    10 kΩ or higher
    A25-29 (IMO) - Body ground
    Always
    10 kΩ or higher
    A25-28 (IMI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


8.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (ECM WAS DEFECTIVE)