DTC B1500 Fuel Sender Open Detected |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1500 | When IG voltage is 9.5 V or more and the following condition is detected:
|
|

| 1.READ VALUE USING TECHSTREAM (FUEL INPUT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Fuel Input | Fuel input/Min.: 0, Max.: 127.5 | Fuel receiver gauge indicates F: 57.0 | Unit: Liter |
| Fuel receiver gauge indicates 3/4: 48.3 | |||
| Fuel receiver gauge indicates 1/2: 32.2 | |||
| Fuel receiver gauge indicates 1/4: 16.1 | |||
| Fuel receiver gauge indicates E: 6.4 |
| Result | Proceed to |
| Fuel level data can be displayed on the Techstream and DTC B1500 is output. | A |
| Fuel level data cannot be displayed on the Techstream. | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the I18 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I18-18 (FR) - I18-17 (FE) | Always | 13.5 to 414.5 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY) |
Disconnect the N11 fuel sender gauge assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I18-18 (FR) - N11-2 (FS) | Always | Below 1 Ω |
| I18-18 (FR) - Body ground | Always | 10 kΩ or higher |
| I18-17 (FE) - N11-3 (FE) | Always | Below 1 Ω |
| I18-17 (FE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT FUEL SENDER GAUGE ASSEMBLY |
![]() |
Remove the fuel sender gauge assembly (Click here for 2AR-FE, Click here for 2GR-FE).
Check that the float moves smoothly between E and F.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Float level is F (upper) | 13.5 to 16.5 Ω |
| 1 - 2 | Float level is between F (upper) and E (lower) | 13.5 to 414.5 Ω (Gradually changes) |
| 1 - 2 | Float level is E (lower) | 405.5 to 414.5 Ω |
| Result | Proceed to |
| OK | A |
| NG (for 2AR-FE) | B |
| NG (for 2GR-FE) | C |
| *a | Front view of wire harness connector (to Fuel Sender Gauge Assembly) |
|
| ||||
|
| ||||
| A | ||
| ||