Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1626    Steering Angle Sensor Failure

for Preparation Click here


DESCRIPTION

This DTC is stored if the navigation ECU sub-assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.

DTC No.
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Steering sensor
  2. Navigation ECU sub-assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

1.REPLACE STEERING SENSOR
  1. Replace the steering sensor (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1626 is output
    A
    No DTCs are output
    B



B
END
A

REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)