Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > Main Switch Circuit

for Preparation Click here


DESCRIPTION

When the blind spot monitor main switch (warning canceling switch assembly) is turned on, a signal is sent to the blind spot monitor sensor RH. The blind spot monitor system operates according to this signal.

WIRING DIAGRAM


E224414E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Blind spot monitor Master / Data list.

  1. According to the display on Techstream, read the Data List.

    Blind Spot Monitor Master 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    BSM Main SW
    Blind spot monitor main switch (warning canceling switch assembly) / ON or OFF
    ON: Blind spot monitor main switch (warning canceling switch assembly) on
    OFF: Blind spot monitor main switch (warning canceling switch assembly) off
    -

    Result:
    Result
    Proceed to
    The display does not change as shown above when the blind spot monitor main switch (warning canceling switch assembly) is operated.
    A
    The display changes as shown above when the blind spot monitor main switch (warning canceling switch assembly) is operated.
    B



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A


2.INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)
  1. Remove the blind spot monitor main switch (warning canceling switch assembly) (Click here).



    E224422E13
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I10-11 (B) - I10-8 (D)
    Blind spot monitor main switch assembly is on (not protruding)
    Below 1 Ω
    I10-11 (B) - I10-8 (D)
    Blind spot monitor main switch assembly is off (protruding)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))



NG
REPLACE BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR MAIN SWITCH - BATTERY)
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I10-11 (B) - Body ground
    Ignition switch ON
    11 to 14 V
    I10-11 (B) - Body ground
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR MAIN SWITCH - BLIND SPOT MONITOR SENSOR RH)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O28-3 (BSSW) - I10-8 (D)
    Always
    Below 1 Ω
    O28-3 (BSSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)