DTC U0233 Lost Communication with Blind Spot Monitor Master Module |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0233 | The blind spot monitor sensor LH cannot receive signals from the blind spot monitor sensor RH. |
|
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check for CAN communication system DTCs (Click here).
|
| ||||
| OK | |
| 2.REPLACE BLIND SPOT MONITOR SENSOR RH |
Replace the blind spot monitor sensor RH (Click here).
| NEXT | |
| 3.RECHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||