Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB8    Destination Information Undefined

for Preparation Click here


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC No.
DTC Detection Condition
Trouble Area
C1AB8
The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).
  1. CAN communication system
  2. Main body ECU (multiplex network body ECU)
  3. Blind spot monitor sensor RH
  4. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK DTC
  1. Check for CAN communication system DTCs (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Replace the main body ECU (multiplex network body ECU) (Click here).


NEXT


3.RECHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    Result:
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor Master
    B
    DTC is output from the blind spot monitor Slave
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

END