AUDIO AND VISUAL SYSTEM (for Radio and Display Type with Intuitive Parking Assist System) > PRECAUTION |
| 1.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
| 2.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL |
| System Name | See Procedure |
| Parking Assist Monitor System |
Click here
|
| 3.PRECAUTIONS FOR RADIO AND DISPLAY RECEIVER ASSEMBLY |
A Hard Disk Drive (HDD) is built into the radio and display receiver assembly to store multi-media data, and is used for the audio and visual system. Therefore, care must be taken for the following points when handling:

When it is necessary to replace the navigation ECU sub-assembly, be sure to replace it with a new one.
Do not apply any vibration or shock to the radio and display receiver assembly.
Do not remove the radio and display receiver assembly if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the radio and display receiver assembly away from magnets or magnetized items.
| 4.PRECAUTIONS FOR HARD DISK DRIVE (HDD) |
Multi-media data for the audio and visual system is stored on the Hard Disk Drive (HDD). Make sure to follow the following instructions when replacing the HDD:
The HDD must only be replaced with a new one. Do not attempt to install a used HDD from another vehicle.
![]() |
Do not touch the HDD cover.
Do not apply any vibration or shock to the HDD.
Do not remove the HDD if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the HDD away from magnets or magnetized items.
Inspect after HDD replacement.