Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1691    Back Camera Initialization Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when the navigation ECU sub-assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).

DTC No.
DTC Detection Condition
Trouble Area
C1691
Back camera initial setting has not been memorized
  1. Rear television camera optical axis adjustment
  2. Navigation ECU sub-assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

1.ADJUST SETTINGS (CAMERA POSITION SETTING)
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation ECU sub-assembly.

    1. Rear television camera optical axis adjustment (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1691 is output
    A
    DTCs are not output
    B

    HINT:
    1. If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
    2. If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the navigation ECU sub-assembly.



B
END
A

REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)